Microsecond Timer | Fakopp

USAGE INSTRUCTIONS

Connect the transducers to the timer box and power on the timer. Press the "Reset" button before each hit, or activate the auto-reset function by switching on the timer while holding down the "Reset" button. In the latter case, the actual readout appears on the screen after each hit without requiring an additional "Reset" press. Since the transducers are identical, choose the one connected to the "Start" connector, identifiable by a color mark. Strike the start sensor using a hammer, ensuring the hit is parallel to the direction of the nail. Utilize a rubber hammer for driving in the sensors and a 100 g steel hammer for measurement. Allow the hammer to spring back. After usage, turn off the unit.

• Time required for one measurement*: less than 1 minute
• Time measurement error: ± 3 microseconds
• Size**: 45 x 82 x 150 mm 
• Weight: 347 g
• Battery: standard rechargeable 9V
• Power consumption: 320 mW 
• Device box: plastic, not water-resistant
• Screen: 4 digit LCD screen Sensors SD02 piezo sensor: Sensor connectors BNC
• RS232: baud rate 2400 bps, data format ASCII connector DIL 9, male
• Operating temperature range: 0-40 °C

*including mounting and removing both sensors 

**without sensors