UV Intensity Monitor : Rail DIN
chevron_left chevron_right

UV Intensity Monitor : Rail DIN | EIT 2.0

EIT is a contitioning whith conpact sensor                                                                                                                                                                                                                                       


EIT DIN Rail: The Compact Sensor works with the EIT DIN Rail to provide a signal (0-10 volt or 4-20 milliAmp) proportional to the real time UV intensity.  The signal from the DIN Rail allows the user to track the relative real-time intensity on a PLC or display. The DIN Rail also allows the user to set low limit alarms and/or close a relay if the pre-programmed limits are exceeded.  


  • Signal conditioning unit used with Compact Sensor
  • Continuously monitors the output of a single UV LED or lamp
  • Provides 0-10 Volt or 4-20 milliAmp analog output with user-settable alarm points and relay closure output connections
  • Snap-in DIN Rail mounting convenience
  • Powered by 24 volts AC/DC
  • The DIN Rail is a Signal Conditioner that is used in a 1:1 ratio with the Compact Sensor
  • Powered by 24 Volts (AC/DC), the DIN Rail continuously the monitors the UV source and provides either a 0-10 V or 4-20 mA signal proportional to the UV intensity
  • Alarm set points and/or alarm contacts are available in the DIN Rail  


You might also like

8 other products in the same category: